TX Modbus consumption is normally less than 74mA at 12V. While sending periodic message frames, there may be peaks at 140mA.
To avoid any problems please maintain 1A 12V on the power terminal block.
Related Articles
- [Proprietary mode] How to reset the receiver to factory settings
- [Proprietary mode] What is the default IP address of the receiver ?
- [Proprietary mode] What is the maximum pulse count ?
- [Proprietary mode] Why is there a red reloading icon next to my transmitter on the IP server of the receiver ?
- [Proprietary mode] What is the receiver's power consumption ?
- [Proprietary mode] How to decode the contact status of the TX CONTACT in the Modbus table
- [Proprietary mode] How to decode the battery status in the Modbus table
- [Proprietary mode] How to decode the battery status in the Bacnet objects
- [Proprietary Mode] Maximum frequency of Modbus requests
- [LoRaWAN] I can't connect my transmitter to the network
- [LoRaWAN] ADR management
- [LoRaWAN] Which port should downlinks be sent to ?
- [LoRaWAN] Behaviour of Joins and LinkChecks
- [LoRaWAN] Minimum transmission periodicity
- [LoRaWAN] LoRaWAN version
- Transmitters calibration
- VOC monitoring-related questions
- Maximum length of the cable on pulse transmitters
- Products warranty duration
- Data Encryption
- TX Pulse wiring
- TX 4-20mA wiring
- [Proprietary Mode] How to change the IP address of the receiver ?
- [Proprietary Mode] Read the total number of Pulses of a Pulse transmitter in BACnet objects
- [LoRaWAN] How to switch from one LoRaWAN network to another ?
- Managing and resetting the index of a Pulse transmitter
- [LoRaWAN] How to change the transmission period of a transmitter in LoRaWAN?
- Compatibility between smart metering transmitters and meters :
- Fixed orange LED on my sensor
- TX contact wiring