The power consumption is normally less than 50mA at 12V. During the installation phase of the sensors, there may be peaks of 500mA.
To avoid any problems please maintain 1A 12V on the power supply terminal block.
Related Articles
- I can't download the F.C.T software
- Cannot start the F.C.T software
- No messages between the sensors and the receiver on the F.C.T software
- Contact status (open closed) for TX CONTACT
- Timeout message in the F.C.T. software dialog box
- I no longer receive messages in the "View transmitter network" tab of the F.C.T. software
- Maximum frequency of Modbus requests
- My transmitter does not restart
- Transmitters calibration
- Maximum length of the cable on pulse transmitters
- Products warranty duration
- TX Pulse wiring
- What is the maximum pulse count ?
- Managing and resetting the index of a Pulse transmitter