The data frames of the transmitters are only displayed in the "View Transmitter Network" tab when the receiver is in USB mode. If messages are not being received, check the switches are in the correct position.
Related Articles
- I can't download the F.C.T software
- Cannot start the F.C.T software
- What is the power consumption of the RX MODBUS 169MHz receiver?
- No messages between the sensors and the receiver on the F.C.T software
- Contact status (open closed) for TX CONTACT
- Timeout message in the F.C.T. software dialog box
- Maximum frequency of Modbus requests
- My transmitter does not restart
- Transmitters calibration
- Maximum length of the cable on pulse transmitters
- Products warranty duration
- TX Pulse wiring
- What is the maximum pulse count ?
- Managing and resetting the index of a Pulse transmitter