Only the CO2 sensors can be calibrated.
The TX CO2 TEMP HUM AMB 100-013 transmitters switch between two modes when you power them:
- Communication mode
- Calibration mode
⚠ Each mode will be activated every other time when powering the transmitter.
⚠ Prior calibration is mandatory before any first use. Before installing your CO2 transmitter, you will have to force the calibration on a "fresh air" basis (preferably outdoors).
For more information on the calibration of 100-013 transmitters, please refer to Appendix 6 of the setup guide available here :
https://enless-wireless.com/wp-content/uploads/2021/06/Setup-guide-Sigfox-High-Power-RCZ1-transmitters_i-1.pdf